Preparation of Tools and Materials

·Main unit of the dash cam (including a 3M adhesive bracket)
.2K rear camera (including 3M adhesive)
·Power supply cable with a car charger (cigarette lighter power cable)Cable for the rear camera
·Cable clips (used to fix and protect cables)
·High-speed memory card (64GB)
·Prying bar (used for hiding the routed wires)
·Alcohol wipes or glass cleaner (to be prepared by oneself)
·Dry cloth (to be prepared by oneself)
.Electrostatic sticker (to prevent the 3M adhesive from sticking directly to the glass, making it easier to remove in the later stage)

Wire Layout In The Vehicle

1.The car charger is connected to the cigar socket.
2.Connect the other end of the car charger to the dash cam.
3.Use the crowbar to run the power cable along the front windshield and the roof, and hide the cable down
the A-pillar so as not to block the drivers sight and cause danger

1.png

2.png

Mount The Rear Camera

1.Please use a clean cloth to wipe the area on the windshield where the dash camera needs to be installed.
2.Peel off the electrostatic sticker, transfer it to the place you want to stick it.Drain the air bubbles on the electrostatic sticker.
3.Peel off the adhesive on the rear camera and stick it on the electrostatic sticker.

3.png

Caution:

·Fix the recorder to the front windshield of the car. (As shown in the figure above)

1. Install the suction cup mount and press it firmly for 10 seconds. Ensure that the adhesion is firm.
2. Adjust the camera angle to capture the road ahead.
3.Manually format the memory card every 1 to 2 months to extend its service life.
4.After the installation is completed, check whether the lens protective film has been removed or if there are any stains on the lens.
5.Avoid direct exposure of the 3M adhesive to the sun in a high-temperature environment to prevent it from falling off.